Contract Manufacturing

We undertake a wide range of contract manufacturing and OEM,
including resin synthesis, polymerization, compounding, mixing, and solvent replacement.

We also manufacture and fill small quantities, and we also have a dedicated silicone machine stand.
If you have any questions, please contact us.

Equipment Introduction

Capacity Material Temperature (degree) Notes
50L SUS304 5 to 95
Hot water, Chiller water
50L SUS316 5 to 95
Hot water, Chiller water
100L SUS316 5 to 95
Hot water, Chiller water
100L SUS316 5 to 95 Silicon-related dedicated machine stand
200L SUS316 5 to 120 Steam, warm water, chiller water
200L SUS316 5 to 120 Steam, warm water, chiller water
1200L SUS316 5 to 120 Steam, warm water, chiller water
1200L SUS316 5 to 140 Steam, warm water, chiller water
1200L SUS316 5 to 140 With decanter
18L SUS304 5 to 95 Two-wheel mixer, low/high speed

Filling and refilling

We can handle small quantities of a few grams.　(Obtained Marketing license for cosmetics and manufacuturing license for cosmetics)
The clean room enables filling and plugging in an environment where foreign matter is controlled.
Equipped with a yellow light to ensure the stability of UV-curable resin.

  • Filling container

  • Cosmetics filling room

  • Outlet from Vessel

Order Manufacturing Flow

  • 1. Consultation from the customer
    Please let us know your requirements by visiting us, calling us, or filling out the inquiry form.
  • 2. Conclusion of Confidentiality Agreement
    Conclude a confidentiality agreement, if necessary. You can discuss the content and conclusion date of the agreement with us.
  • 3. Confirmation of Technical Information
    Discuss technical information for sample work and actual production.
  • 4. Lab Sample Creation
    We will make a sample within one month. Based on the results of your evaluation, we will mutually check the quality of the sample.
    If any improvement is required, we will manufacture a new sample again.
  • 5. Estimate Presentation
    Make a rough estimate at the time of lab synthesis.
  • 6. Pilot Production
    We will conduct pilot production within one month after the lab evaluation.
    We will decide the optimum quantity for commercial production with you and conduct pilot production.
  • 7. Evaluation of Pilot Production
     
  • 8. Conclusion of Contract Manufacturing Agreement
    If necessary, we conclude a contract manufacturing agreement with you.
  • 9. Determination of Product Standard
    After the evaluation of the commercial product, we will determine the standard values.
  • 10. Start of Commercial Production